Everpure Certified Portworx Enterprise Professional 試験対策問題集

模擬試験モードの設定

上記は本サイトの模擬試験モードの設定値です。実際の試験の出題数・制限時間・合格基準は、各認定プログラムの公式サイトでご確認ください。

出題分野

• Deploy and Install（前提条件と導入）（出題比率 20%）
• Operations and Administration（運用と拡張）（出題比率 25%）
• Security（認証・暗号化・証明書）（出題比率 10%）
• Observability and Troubleshooting（監視と切り分け）（出題比率 20%）
• Data Management and Availability（スナップショットと DR）（出題比率 25%）

フリー問題

1. In a six node cluster the engineer leaves two nodes without any device of their …
2. The team is deciding whether the key value store will run outside the cluster or…
3. To prove that the platform really serves volumes, the engineer creates one small…
4. Before Portworx is installed on a bare metal cluster, the engineer runs two sepa…
5. A volume is slow and the engineer needs to know which nodes hold its copies. Two…
6. A cluster with no route to the internet has to move to a newer platform version.…
7. After a change the engineer checks two surfaces: the platform command line and t…
8. Two optional pieces are enabled in the same cluster: the scheduling helper that …
9. A pool is nearly full this week, and next quarter the same cluster is expected t…
10. Security has just been switched on in a cluster where the operators used to run …
11. Encrypted volumes are replicated to a second cluster for disaster recovery. The …
12. A dashboard set ships with two boards: one per volume and one per pool. A new me…
13. One member of the internal key value store is gone because its node was reimaged…
14. A team adds the platform to an existing monitoring stack and then complains that…
15. During a planned maintenance window the same alert pages the on call engineer ev…
16. After a failover the volumes are available on the second site, but the clients s…
17. One application spreads its data over three volumes: data, log, and index. If ea…
18. Before anything can be replicated the two clusters have to be introduced to each…
19. A team asks for two kinds of snapshot: one that has to be usable within seconds …
20. For the strictest case the snapshot has to be taken while the application is not…